PUMPS

Great little 12VDC oil-less diaphragm style air pump. For you techies out there it draws 40-300mA, 2.0 Litres/min, 350mm Hg max pressure. These are takeouts and in great condition but the leads on yours may vary in length or even be clipped off (Just...

it's Shower Time New surplus is the best! This Maric, Made in USA 12VDC Demand/Delivery pump is typically used to pump water on-demand (duh) in an instant when power is applied to the two 8" red/black leads. Think shower/faucet on a boat or an RV coming...

Nifty device that takes maxi air and squeezes it down into a mini condition. The device is roughly 6-1/2"" long x 6" tall x 4" wide. It has a 10 ft. cord that plugs into an auto lighter socket: i.e. it runs on 12VDC @ 10 amps. Air output is via a 12"...

This 20 GPM (gallons per minute) submersible fluid pump will shoot fluid approx (15) feet upward. Fits standard garden hose, Comes with (4) rubber feet and It even includes a brass barbed hose connector for 8mm hoses etc. Unit measures 7" x 5-1/4" x 4"...

Submersible Pumps Here are the ins and outs of submersible pumps for your DIY fountain.These small electric pumps run on 24 VAC (For low energy consumption.) from the included wall outlet adapter, are rated for continuous duty,...

From Koge Micro Pump Co. (company motto: Let’s PUMP the World!), this nice little diaphragm air pump draws approx 400mA at 12VDC and will put out 3 liters a minute with a minimum pressure of 400mm/Hg. Measures 2-3/4” long x 1-1/4”...

Pistons Are A Pumpin' It's a beauty folks. These are pretty clean take-outs from what we have been told is a breast pump assemply. They operate from 3VDC up to 12VDC, but that won't matter because we are going to include the wall adapter. (9VDC@2Amps)...

This vacuum pump from Koge Electronics draws 100-250mA at 4.8V and is rated for >2.6L/minimum output and -460mbar of pressure. Measures 2-9/16" x 1-3/16" x 1-5/16" with a 3/16" OD x 3/8" inlet barb and a 3/16" OD x 1/2" tall outlet...

This silver 9VDC air pump with a clear pumping assembly is 3-1/2" x 2” x 3” with a piston behind the clear plastic on one end. Both the 7/16” intake and ¼” output are on one side of the assembly. We couldn't find exact info...

We’re guessing it’s from a medical device, but we know for sure that it’s a pump assembly from The Lee Company of Connecticut. Looks expensive, like it should cost more than ten times our price, and that’s why you shop here. Has a...